« Frontside Nose Grind Video | Main | 50/50 Finger Flip Video »


50/50 Finger Flip

The 50/50 Finger Flip is an old freestyle trick. I learned them sometime in 1979. There are many variations. The move is usually done as a stationary trick, though it is possible to do it from a roll too. Normally I think a rolling one is easier if you start from a fakie.

In this clip, I show you 2 variations of the trick. Besides the one depicted in the sequence below, the clip includes a variant method of getting into the 50/50 fingerflip truck stand position.

Other than that, these are both the very basic versions of this trick.

Check out the video clip here.
5050ff6.jpg
5050ff6.jpg 5050ff6.jpg

In frame 1, I start the trick from a stationary tail stall position. I reach down and grab the nose, with my hand fliped over (my fingers are on top of the board, and my thumb is under it. Your rear foot should be on the tail, not half on the tail/half on the ground. It will probably be on the very tip of the tail.

In frame 2, I start to jump. As I lift off the ground, I begin turning the board over with my hand.

5050ff6.jpg 5050ff6.jpg

In frames 3 and 4, I turn the board over, landing with my rear foot on the truck. I'm balancing on the tip of the tail, with my lead hand still grabbing the nose.

This is a spot where you can play around a lot. You can balance in this position and switch feet, use both hands to hold the nose while you wrap your front foot around the nose (this is a 50/50 wrap-around), etc.

5050ff6.jpg 5050ff6.jpg

After standing briefly on the truck, its time to come back down. You just hop up a little bit and use your hand to complete the other 50% of the finger flip.

5050ff6.jpg 5050ff6.jpg

I land solidly in a pretty normal riding position.

There are so many variations possible. For instance, instead of coming back down with a simple 1/2 flip, try doing a 1 1/2 flip instead. Or how about a 180 added in, for a 50/50 finger flip to varial re-entry. Or even a single flip re-entry to casper...the possibilities are endless...